Repair Procedures

Removal

CAUTION:
- Do not spill brake fluid on the vehicle; it may damage the paint if brake fluid does contact the paint, wash it off immediately with water.

1. Disconnect the push rod from the master cylinder by removing the snap pin (A) and washer (B).




2. Remove the master cylinder mounting nuts (A-2ea).

Tightening torque:
(A) 16.7 - 25.5 N.m (1.7 - 2.6 kgf.m, 12.3 - 18.8 lb-ft)




3. Remove the battery and ECM.

4. Disconnect the clutch tube (B) and reservoir hose (A) from the clutch master cylinder (C).
5. Remove the clutch master cylinder assembly (C).






Installation

1. Installation is the reverse of removal.

NOTE:
- Perform bleeding air procedure in clutch release cylinder after pouring the brake fluid.