Repair Procedures

Replacement

1. Remove the floor console assembly.

2. Loosen the mounting nut (A) and then remove the shift lock cable from the shift lock cam (B).

Tightening torque:
9.8 - 13.7 N.m (1.0 - 1.4 kgf.m, 7.2 - 10.1 lb-ft)




3. Remove the snap pin (B) and shift lock cable (C) from the brake pedal assembly (A).




4. Installation is the reverse of removal.

NOTE:
Adjust the shift lock cable after installing.


Adjustment

Adjusting method for shift lock cable
1. Install the snap pin (B) and shift lock cable (C) to brake pedal assembly (A).




2. Move the shift lever to P range.
3. Temporarily install shift lock cable to P lock cam fixing pin (B).
4. Slightly pull outer casing of shift lock cable to direction "E", this prevents shift lock cable from being lose.
5. After checking portion of cable end touches cable fixing pin of P lock cam, tighten the nut (A).

Tightening torque:
9.8 - 13.7 N.m (1.0 - 1.4 kgf.m, 7.2 - 10.1 lb-ft)




6. Again check that cable end touches.

Inspection

1. With shift lever at "P" position and brake pedal not depressed, push button can not operated.(shift lever can not be shifted to other positions from "P") push button can be operated at the positions except "P".
2. With brake pedal stroke 15 - 25mm (with shift lever at "P" position), push button can be operated and shift lever can be shifted to smoothly to other from "P".
3. With brake pedal not depressed, shift lever can be shifted smoothly to "P" positions from other position.