Electric Oil Pump (EOP)

Removal

1. Disconnect the battery negative cable from the battery and then wait for at least 30 seconds.
2. Disconnect the Electric Oil Pump (EOP) connector (A).




3. Remove the under cover (A).

Tightening torque:
6.9 - 10.8 N.m (0.7 - 1.1 kgf.m, 5.1 - 8.0 lb-ft)




4. Remove the Electric Oil Pump (B) by loosening bolts (A-4ea).

Tightening torque:
19.6 - 25.5 N.m (2.0 - 2.6 kgf.m, 14.5 - 18.8 lb-ft)





Installation

1. Install is the reverse of the removal.

NOTE:
- Must be replaced with new O ring when assembling.
- Adding automatic transaxle fluid.