W/Harness Inspection

Engine Control
P0017 Crankshaft Position - Camshaft Position Correlation (Bank 1 Sensor B) - Inspection/Repair:_:W/Harness Inspection

Terminal & Connector Inspection

1. Many malfunctions in the electrical system are caused by poor harness and terminals. Faults can also be caused by interference from other electrical systems, and mechanical or chemical damage.
2. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage.
3. Has a problem been found?






CMPS Circuit Inspection

Check voltage
1. IG "OFF".
2. Disconnect CMPS connector.
3. IG "ON" & ENG "OFF".
4. Measure the voltage between Power, Signal, Ground terminal of CMPS harness connector and chassis ground.

Specification :
Power Terminal Approx. 5V
Signal Terminal Approx. 5V
Ground Terminal Approx. 0V








5. Is the measured voltage within specification?






CKPS circuit inspection(W/O ISG)

Check voltage
1. IG "OFF".
2. Disconnect CKPS connector.
3. IG "ON" & ENG "OFF".
4. Measure the voltage between Hi, Low terminal of CKPS harness connector and chassis ground.

Specification :Approx. 2.5 V








5. Is the measured voltage within specification?






CKPS circuit inspection(ISG)

Check voltage
1. IG "OFF".
2. Disconnect CKPS connector.
3. IG "ON" & ENG "OFF".
4. Measure the voltage between Power, Signal, Ground terminal of CKPS harness connector and chassis ground.

Specification :
Power Terminal Approx. 5V
Signal Terminal Approx. 4.7V
Ground Terminal Approx. 0V








5. Is the measured voltage within specification?