Parking Brake Shoe: Service and Repair

Removal

Parking Brake Shoe (Disc Brake Type)

1. Raise the vehicle, and make sure it is securely supported.
2. Remove the rear tire and wheel, then remove the brake caliper.
3. Remove the parking brake cable (B), after remove the clip (A).




4. Remove the shoe hold down pin (A) and spring (B) by pressing and rotating the spring.




5. Remove the adjuster assembly (B) and the lower return spring (A).




6. Remove the upper return spring (C) and the brake shoes (D).
7. Remove the operating lever assembly (E).

Installation

Parking Brake Shoe (Disc Brake Type)

1. Install the operating lever assembly (E).




2. Install the upper return spring (C) and the brake shoes (D).
3. Install the adjuster assembly (B) and the lower return spring (A).
4. Install the shoe hold down pin (A) and spring (B) by pressing and rotating the spring.




5. Install the parking brake cable (B), then install the clip (A).




6. Install the rear brake disc, then adjust the rear brake shoe clearance.
(1) Remove the plug from the disc.
(2) Rotate the toothed wheel of adjuster by a screw driver until the disc is not moving, and then return it by 5 notches in the opposite direction.




7. Install the brake caliper.
8. Install the tire and wheel.
9. Adjust the parking brake pedal.
10. If the parking brake shoe or the brake disc are replaced a newly one, perform the brake shoe bed-in procedure.
(1) While operating the parking brake pedal for 98 N(10 kgf, 22 lb) effort, drive the vehicle 500 meters (0.31 miles) at the speed of 60 kph (37.3 mph).
(2) Repeat the above procedure more than two times.
(3) Must be held on at 30% grade.

CAUTION:
After adjusting parking brake, verify the following ;
1. Must be free from malfunction when the parking pedal is operated at 981N(100 kgf, 220 lb).
2. Check that all parts move smoothly.
3. The parking brake indicator lamp must be on after the parking pedal is applied and must be off after the pedal is released.