Parking Brake Pedal: Service and Repair

Removal

Parking Brake Pedal

1. Remove the lower panel, after removing the parking brake release lever.
2. Disconnect the parking brake switch connector(A).




3. Remove the cable adjusting nut(B) and the mounting clip(C), then remove the parking brake cable(D).
4. Remove the parking brake pedal mounting bolts and nut(E), then remove the parking brake pedal.
5. Remove the floor console. .
6. Remove the parking brake cable(A).






Installation

Parking Brake Pedal

1. Install the parking brake cable(A).




2. Install the floor console. .
3. Install the parking brake pedal , and then install the parking brake pedal mounting bolts and nut(E).




4. Install the parking brake cable(D) , and then install the mounting clip(C).
5. Adjust the parking brake pedal stroke by turning the adjusting nut(B).
(1) Push the parking brake pedal to its maximum point of travel.
Releas and repeat 2 additional times.
Adjust the nut (B) so that the parking brake pedal stroke is 88 - 98mm(3.46 - 3.86in) at an operating effort of 196N(20kgf, 44lb).

NOTE:
1. The parking brake adjustment must be carried out after adjusting the rear shoe.
2. After adjusting parking brake, verify the following ;
1) Must be free from interference between adjusting nut and pin.
2) Verify that the brake is not dragging.

6. Reconnect the parking brake switch connector(A).
7. Install the lower panel, and then install the parking brake release lever.