Repair Procedures

INSPECTION

LIGHTING SWITCH INSPECTION
1. With the multi function switch in each position, make sure that continuity exists between the terminals below.
If continuity is not as specified, replace the multi-function switch





LIGHTING SWITCH





DIMMER AND PASSING SWITCH





TURN SIGNAL SWITCH





FRONT FOG LAMP





WIPER AND WASHER SWITCH INSPECTION
1. With the multi function switch in each position, make sure that continuity exists between the terminals below.
If continuity is not as specified, replace the multi-function switch.





WIPER SWITCH





WASHER SWITCH





REAR WIPER & WASHER SWITCH






REMOVAL

1. Disconnect the negative (-) battery terminal.
2. Remove the steering column upper and lower shrouds (A) after removing 3 screws.
.




3. Remove the light switch (A) by pushing the lock pin (B) after disconnecting the connector.




4. Remove the wiper switch (A) by pushing the lock pin (B) after disconnecting the connector.






INSTALLATION

1. Install the wiper switch after connecting the connector.
2. Install the light switch after connecting the connector.
3. Install the steering column upper and lower shrouds.