Verification of Vehicle Repair

ABS/ESC(MGH-25)
C1283 Yaw rate and lateral G sensor - signal - Verification of Vehicle Repair

Verification of Vehicle Repair

After a repair, it is essential to verify that the fault has been corrected.
1. Connect scantool and select "Diagnostic Trouble Codes(DTCs)" mode
2. Using a scantool, Clear DTC.
3. Operate the vehicle within DTC Detecting Condition in General Information.
4. Are any DTCs present ?
YES
1) Go to the applicable troubleshooting procedure.
NO
1) System performing to specification at this time.