Rear Door Window Glass: Service and Repair

Replacement

Glass Replacement
[5 Door]
1. Remove the following items :
A. Rear door trim.
2. After loosening the mounting screw, then remove the rear door inside handle (A).




3. Disconnect the rear door inside handle cable (A).




4. Disconnect the rear door speaker connector (A).




5. After loosening the mounting screws, then remove the rear door trim seal mounting bracket (B).
6. Remove the rear door trim seal (A).

NOTE:
- Replace any damaged door trim seal.




7. Loosen the rear door delta molding mounting screws.




8. Remove the rear door delta molding (A).




9. Loosen the rear door channel mounting nuts.

Tightening torque :
3.9 - 5.9 N.m (0.4 - 0.6 kgf.m, 2.9 - 4.3 lb-ft)




10. Remove the rear door belt inside weatherstrip (A).




11. Carefully move the glass (A) until you can see the bolts, then loosen them. Separate the glass from the glass run and carefully pull the glass out through the window slot.

CAUTION:
- Take care not to drop to glass and scratch the glass surface.

Tightening torque :
7.8 - 11.8 N.m (0.8 - 1.2 kgf.m, 5.8 - 8.7 lb-ft)




12. Installation is the reverse of removal.

NOTE:

A. Roll the glass up down to see if it move freely without binding.
B. Adjust the position of the glass as necessary.
[4 Door]
1. Remove the rear door trim.
2. After loosening the mounting screw, then remove the rear door inside handle (A).




3. Disconnect the rear door inside handle cable (A).




4. Disconnect the rear door speaker connector (A).




5. After loosening the mounting screws, then remove the rear door trim seal mounting bracket (B).
6. Remove the rear door trim seal (A).

NOTE:
- Replace any damaged door trim seal.




7. After loosening the mounting screw, then remove the rear door inside handle (A).




8. After loosening the mounting screws, then remove the rear door belt outside weatherstrip (A).




9. Loosen the rear door window run & fixed glass (A) mounting screw and bolt.




10. Remove the rear door window run & fixed glass (A).




11. Loosen the rear door channel mounting nuts.

Tightening torque :
3.9 - 5.9 N.m (0.4 - 0.6 kgf.m, 2.9 - 4.3 lb-ft)




12. Carefully move the glass (A) until you can see the bolts, then loosen them. Separate the glass from the glass run and carefully pull the glass out through the window slot.

CAUTION:
- Take care not to drop to glass and scratch the glass surface.

Tightening torque :
7.8 - 11.8 N.m (0.8 - 1.2 kgf.m, 5.8 - 8.7 lb-ft)




13. Installation is the reverse of removal.

NOTE:

A. Roll the glass up down to see if it move freely without binding.
B. Adjust the position of the glass as necessary.
C. Make sure connectors are connected properly and each rod is connected securely.
D. Make sure the door lock and opens properly.
E. Replace any damaged clips.