Repair Procedures

Removal

Shift Lever Assembly Replacement
1. Remove the floor Interior console assembly.

2. Remove the heater duct (A).




3. Remove the select cable assembly after removing select cable snap pin (A) and clip (B).




4. Remove the shift lever assembly (B) by removing the bolts (A-4ea).

Tightening torque:
8.8 - 13.7 N.m (0.9 - 1.4 kgf.m, 6.5 - 10.1 lb-ft)




5. Remove the shift lever assembly (B) by removing the clip (A).

CAUTION:
- Set securely.








Select / Shift Cable Replacement
1. Remove the floor Interior console assembly.

2. Remove the heater duct (A).




3. Remove the select cable assembly after removing select cable snap pin (A) and clip (B).




4. Remove the shift lever assembly (B) by removing the bolts (A-4ea).

Tightening torque:
8.8 - 13.7 N.m (0.9 - 1.4 kgf.m, 6.5 - 10.1 lb-ft)




5. Remove the clip (A) from the shift cable assembly.

CAUTION:
- Set securely.








6. Remove the crash pad.

7. Remove the heater unit.

8. Remove the retainer (A) and nuts (B-2ea).

Tightening torque:
11.8 - 14.7 N.m (1.2 - 1.5 kgf.m, 8.7 - 10.8 lb-ft)








9. Remove the pins (A).
10. Remove the cable (B) from the cable bracket at manual transaxle assembly side.
11. Remove the shift cable and select cable at cabin room.




12. Installation is the reverse of removal.

[Shift / Select Cable Installation Tips]
1. Installation the select and shift cable assembly (B) after removing the pin (A).




2. Installation is the shift cable (A).

CAUTION:
At this time, have to disconnect select cable.




3. Installation is the shift lever assembly (A).

Tightening torque:
8.8 - 13.7 N.m (0.9 - 1.4 kgf.m, 6.5 - 10.1 lb-ft)




4. Shift to the 3th gear position.
5. Insert the selected cable (A) to the shift lever assembly pin (B).
6. You have to push in the adjuster (C).
7. Remove the neutral position pin (D).
8. Install the snap pin (E).






Inspection

1. Check the select cable for proper operation and for damage.
2. Check the shift cable for proper operation and for damage.
3. Check the boots for damage.
4. Check the boots for wear abrasion sticking, restricted movement or damage.
5. Check for the weak or damaged spring.

Adjustment

1. In neutral position, disjoin select cable (A) from shift lever assembly pin (B).




2. Disconnect select adjuster (A) to an arrow.




3. Shift to the 3th gear position.
4. Adjustment adjuster (B) on select cable (A) as rolling from side to side.




5. Insert on free load and press the adjuster.
6. After shifting 2nd gear, checking the left select gap about 1mm(if not, loop no, 1 - 5)

NOTE:
If there are still gate blocking in spite of re-adjustment, shift lever assembly stopper stoke must be checked.

7. In neutral position, join by clip (A).