Repair procedures

Replacement

1. Remove the front driveshaft.
2. Remove the TJ joint assembly.
3. Remove the remove the both side of band (B) of the dynamic damper (A).




4. Fix the driveshaft (A) with a vice (B) as illustrated.




5. Apply soap powder on the shaft to prevent being damaged between the shaft spline and the dynamic damper when the dynamic damper is removed.
6. Separate the dynamic damper (A) from the shaft (B) carefully.






Installation

1. Apply soap powder on the shaft to prevent being damaged between the shaft spline and the dynamic damper.
2. Install the dynamic damper.
3. Install the dynamic damper band.
4. Using the SST(09495-3K000), secure the TJ boot bands (A).

Clearance (A):2.0 mm (0.079 in) or less




5. Install the TJ joint assembly.
6. Install the front driveshaft.