Repair Procedures

Removal

1. Remove the battery and the battery tray.

2. Remove the under cover (A).

Tightening torque:
6.9 - 10.8 N.m (0.7 - 1.1 kgf.m, 5.1 - 8.0 lb-ft)




3. Replace new gasket and the plug after draining the automatic transaxle fluid by removing the drain plug.
4. Remove the valve body cover (B).

Tightening torque:
13.7 - 15.7 N.m (1.4 - 1.6 kgf.m, 10.1 - 11.6 lb-ft)




5. Remove the air breather hose (A).
6. Remove the plate and the detent spring (A) after removing the bolt.

Tightening torque:
11.8 - 15.7 N.m (1.2 - 1.6 kgf.m, 8.7 - 11.6 lb-ft)




7. Remove the bolt (3ea) after disconnecting the solenoid valve (B) connector and the oil temperature sensor connector (A).

Tightening torque:
9.8 - 11.8 N.m (1.0 - 1.2 kgf.m, 7.2 - 8.7 lb-ft)




8. Remove the valve body assembly (A).

Tightening torque:
9.8 - 11.8 N.m (1.0 - 1.2 kgf.m, 7.2 - 8.7 lb-ft)





Installation

1. Installation is the reverse of removal.

CAUTION:
After replacement or reinstallation procedure of the valve body assembly, must perform procedures below.

NOTE:
- The gasket of the valve body gasket (A) use new one.




- Adding automatic transaxle fluid.

- Perform TCM learning after replacing the valve body to prevent slow transaxle response, jerky acceleration and jerky startup.