Starter - With ISG (Idle Stop & Go) System

Removal and Installation

1. Disconnect the battery negative terminal.
2. Remove the air duct and air cleaner assembly.
3. Disconnect the starter cable (B) from the B terminal on the solenoid then disconnect the connector (A) from the S terminal.




4. Remove the 2 bolts holding the starter, then remove the starter (A).

Tighting torque :
42.2 - 53.9 Nm (4.3 - 5.5 kgf.m, 31.1 - 39.8 lb-ft)




5. Installation is the reverse of removal.