Engine Control/Fuel System

Removal and Installation

1. Disconnect the battery negative terminal.

Tightening torque
Without battery sensor :
7.8 - 9.8 N.m (0.8 - 1.0 kgf.m, 5.8 - 7.2 lb-ft)
With battery sensor :
4.0 - 6.0 N.m (0.4 - 0.6 kgf.m, 3.0 - 4.4 lb-ft)

2. Remove the glove box housing.
3. Disconnect the connector (A) and then remove the DC/DC converter (B).




4. Installation is reverse order of removal.

NOTE:
After disconnecting then reconnecting the battery negative cable, the ISG function dose not operates until the system is stabilized, about 4 hours.