Front Seat Belt

Replacement

Front Seat Belt Replacement

CAUTION:
- When installing the belt, make sure not to damaged the pretensioner.

1. Remove the following items first :
A. Front seat assembly

B. Front door scuff trim & Rear door scuff trim

2. Disconnect the battery negative cable, and wait for at least three minutes before beginning work.
3. The seat belt anchor pretensioner (A) can be removed after pushing the lock pin (B) as arrow direction.

4. Using a screwdriver or remover, remove the center pillar lower trim (A).

5. Using a screwdriver or remover, remove the center pillar upper trim (A).

6. After loosening the mounting bolt, then remove the front seat belt upper anchor (A).

Tightening torque :
39.2 - 53.9 N.m (4.0 - 5.5 kgf.m, 28.8 - 39.8 lb-ft)

7. After disconnecting the pretensioner connector lock pin, remove the seat belt pretensioner connector (A), loosen the mounting bolt, then remove the pretensioner (B).

Tightening torque :
39.2 - 53.9 N.m (4.0 - 5.5 kgf.m, 28.8 - 39.8 lb-ft)

8. Installation is the reverse of removal.

CAUTION:
- Make sure the connector is plugged in properly.
- Replace any damage clips.

Height Adjust Replacement
1. Remove the following items first :
A. Front seat assembly

B. Front door scuff trim & Rear door scuff trim

C. Front seat belt lower anchor
D. Center pillar lower trim

E. Center pillar upper trim

F. Front seat belt upper anchor
2. After loosening the bolts, then remove the height adjustor (A).

Tightening torque :
39.2 - 53.9 N.m (4.0 - 5.5 kgf.m, 28.8 - 39.8 lb-ft)

3. Installation is the reverse of removal.

NOTE:
- Replace ant damaged clips.
- Make sure the height adjust properly.

Front Seat Belt Buckle Replacement
1. Remove the following items first :
A. Front seat assembly

2. Remove the front seat belt buckle connector mounting clip (A).

3. After loosening the mounting bolt, then remove the front seat belt buckle (A).

Tightening torque :
39.2 - 53.9 N.m (4.0 - 5.5 kgf.m, 28.8 - 39.8 lb-ft)

4. Installation is the reverse of removal.