SS-B Solenoid Valve (ON/OFF)

Inspection

1. Turn ignition switch OFF.
2. Disconnect the solenoid valve connector.
3. Measure resistance between sensor signal terminal and sensor ground terminal.
4. Check that the resistance is within the specification.

Removal

1. Remove the battery and the battery tray.

2. Remove the under cover (A).

Tightening torque:
6.9 - 10.8 N.m (0.7 - 1.1 kgf.m, 5.1 - 8.0 lb-ft)




3. Replace new gasket and the plug after draining the automatic transaxle fluid by removing the drain plug.
4. Remove the valve body cover (A) and eyebolt (B).

Tightening torque:
13.7 - 15.7 N.m (1.4 - 1.6 kgf.m, 10.1 - 11.6 lb-ft)

CAUTION:
Always replace the gasket of the eyebolt use new one whenever loosening eyebolt.





NOTE:
Remove installation bolts in the engine room first and then remove others under the vehicle.

5. Remove the bolt (3ea) after disconnecting the solenoid valve connector (B) and the oil temperature sensor connector (A).

Tightening torque:
9.8 - 11.8 N.m (1.0 - 1.2 kgf.m, 7.2 - 8.7 lb-ft)




6. Remove the solenoid valve (B) after removing the solenoid support (A).






Installation

1. Installation is the reverse of removal.

NOTE:
- When installing, apply the ATF oil or white vaseline to the O-ring (A) not to be damaged.




- The gasket of the valve body gasket (A) use new one.




- Adding automatic transaxle fluid.