Repair Procedures

Replacement

[Drum Type]
1. Remove the rear wheel & tire.

Tightening torque:
88.3 - 107.9 N.m (9.0 - 11.0 kgf.m, 65.1 - 79.6 lb-ft)




2. Loosen the screw (A) and then remove the disc (B).

Tightening torque:
4.9 - 5.8 N.m (0.5 - 0.6 kgf.m, 3.6 - 4.3 lb-ft)




3. Remove the spring (A, B, C).












4. Remove the shoe (A).




5. Disconnect the parking brake cable (A) from lining (B).




6. Remove the clip (A).




7. Remove the wheel speed sensor (A) & brake hose (B) from the rear axle assembly and then loosen the cylinder bolts (C).

Tightening torque:
A: 6.9 - 10.8 N.m (0.7 - 1.1 kgf.m, 5.1 - 8.0 lb-ft)
B: 12.7 - 16.7 N.m (1.3 - 1.7 kgf.m, 9.4 - 12.3 lb-ft)




8. Loosen the hub mounting bolt and then remove the hub (A) from the torsion beam.

Tightening torque:
49.0 - 58.8 N.m (5.0 - 6.0 kgf.m, 36.2 - 43.4 lb-ft)








9. Install in the reverse order of removal.
[Disc Type]
1. Remove the rear wheel & tire.

Tightening torque:
88.3 - 107.9 N.m (9.0 - 11.0 kgf.m, 65.1 - 79.6 lb-ft)




2. Remove the clip (A) and then remove the parking brake cable (B).




3. Remove the brake caliper assembly (A) from the torsion beam axle by loosening the bolts (B).

Tightening torque:
63.7 - 73.5 N.m(6.5 - 7.5 kgf.m, 47.0 - 54.2 lb-ft)




4. Loosen the screw and remove the disc (A).

Tightening torque:
4.9 - 5.8 N.m (0.5 - 0.6 kgf.m, 3.6 - 4.3 lb-ft)




5. Loosen the hub mounting bolt and then remove the hub (A) from the torsion beam (B).

Tightening torque:
49.0 - 58.8 N.m (5.0 - 6.0 kgf.m, 36.2 - 43.4 lb-ft)








6. Install in the reverse order of removal.

Inspection

1. Check the hub for cracks and the splines for wear.
2. Check the brake disc for scoring and damage.
3. Check the rear axle carrier for cracks
4. Check the bearing for cracks or damage.