Fog/Driving Lamp: Service and Repair

Removal

1. Disconnect the negative (-) battery terminal.
2. Disconnect the fog lamp connector (A).




3. Remove the fog lamp bulb (A) after turning in the counterclockwise direction.




4. Remove the fog lamp assembly (A) with loosening 3 screws.






Installation

1. Install the fog lamp.
2. Reconnect the fog lamp connector.
3. Connect the negative (-) battery terminal.

Inspection

Multifunction Switch(Lighting)
1. Disconnect the negative(-) battery terminal.
2. Remove the lighting switch of the multi-function switch.
3. With the front fog lamp switch, make sure that continuity exists between the terminals below.
If continuity is not as specified, replace the multi-function switch.





Front Fog Lamp Switch