Repair Procedures

Replacement

Sunvisor Replacement

CAUTION:
- Use a plastic panel removal tool to remove interior trip pieces to without marring the surface.
- Put on gloves to protect your hands.

1. After loosening the mounting screws, then remove the sunvisor (A) and retainer (B).




2. Installation is the reverse of removal.

Assist Handle Replacement

CAUTION:
- Use a plastic panel removal tool to remove interior trip pieces to without marring the surface.
- Put on gloves to protect your hands.

1. Remove the covers (B).
2. After loosening the mounting bolts, then remove the assist handle (A).




3. Installation is the reverse of removal.

Overhead Console Replacement

CAUTION:
- Use a plastic panel removal tool to remove interior trip pieces to without marring the surface.
- Put on gloves to protect your hands.

1. Using a screwdriver or remover, remove the overhead console cover (A).




2. After loosening the mounting screws, then remove the overhead console assembly (A).




3. Disconnect the connectors (A).




4. Installation is the reverse of removal.

NOTE:
- Make sure the connector is connected properly.

Room Lamp Replacement

CAUTION:
- Use a plastic panel removal tool to remove interior trip pieces to without marring the surface.
- Put on gloves to protect your hands.

1. Using a screwdriver or remover, remove the room lamp cover (B).
2. After loosening the mounting screws, then remove the room lamp (A).




3. Disconnect the connector (A).




4. Installation is the reverse of removal.

NOTE:
- Make sure the connectors are connected in properly.
- Replace any damage clips.

Vanity Lamp Replacement

CAUTION:
- Use a plastic panel removal tool to remove interior trip pieces to without marring the surface.
- Put on gloves to protect your hands.

1. Using a screwdriver or remover, remove the vanity lamp (A).
2. Disconnect the connector (B).




3. Installation is the reverse of removal.

NOTE:
- Make sure the connectors are connected in properly.
- Replace any damage clips.

Roof Trim Replacement

CAUTION:
- When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
- Put on gloves to protect your hands.

1. Remove the following items :
A. Front seat

B. Rear seat

C. Sunvisor
D. Overhead console
E. Room lamp
F. Sunglass case
G. Assist handle
H. Front pillar trim

I. Front door scuff trim & Rear door scuff trim

J. Center pillar lower trim & Center pillar upper trim

K. Luggage side trim [5 Door]

L. Rear pillar trim

2. Disconnect the roof trim main connector (A).




3. Disconnect the sunroof motor connector (A).




4. Remove the clips and roof trim (A).




5. Installation is the reverse of removal.

NOTE:
- Make sure the connectors are plugged in properly.
- Replace any damage clips.