Front Fender: Service and Repair

Replacement

CAUTION:
- When removing and installing the fender, an assistant is necessary.
- Be careful not to damage the fender and body.
- When removing the clips, use a clip remover.

1. Remove the front bumper cover.

2. Remove the head lamps.

3. Using a screwdriver or remover, remove the front pillar trim (A).




4. Disconnect the tweeter speaker connector (A).




5. Loosen the delta glass mounting nuts.

Tightening torque :
3.9 - 4.4 N.m (0.4 - 0.45 kgf.m, 2.9 - 3.3 lb-ft)




6. Remove the delta glass (A).




7. Loosen the wheel guard (A) mounting screws.




8. After loosening the mounting screws, then remove the front bumper side mounting bracket (A).




9. After loosening the mounting bolts, then remove the fender assembly (A).




10. Installation is the reverse of removal.