Exterior Moulding / Trim: Service and Repair

Replacement

Roof Garnish Replacement

CAUTION:
- When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
- Put on gloves to protect your hands.
- Take care not to scratch the body surface.

1. Using a screwdriver or remover, remove the roof garnish (A).




2. Installation is the reverse of removal.

NOTE:
- Replace any damaged clips.

Delta Glass Replacement

CAUTION:
- When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
- Put on gloves to protect your hands.
- Take care not to scratch the body surface.

1. Remove the following items :
A. Front pillar trim

2. After loosening the mounting nuts, then remove the delta glass (A).

Tightening torque :
3.9 - 4.4 N.m (0.4 - 0.45 kgf.m, 2.9 - 3.3 lb-ft)




3. Installation is the reverse of removal.

NOTE:
- Replace any damaged clips.

Front Wheel Guard Replacement

CAUTION:
- When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
- Put on gloves to protect your hands.
- Take care not to scratch the body surface.

1. Remove the front tire.
2. After loosening the mounting screws and clips, then remove the front wheel guard (A).




3. Installation is the reverse of removal.

NOTE:
- Replace any damaged clips.

Rear Wheel Guard Replacement

CAUTION:
- When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
- Put on gloves to protect your hands.
- Take care not to scratch the body surface.

1. Remove the rear tire.
2. After loosening the mounting clips and screws, then remove the rear wheel guard (A).
[A Type]




[B Type]




3. Installation is the reverse of removal.

NOTE:
- Replace any damaged clips.

Front Mud Guard Replacement

CAUTION:
- When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
- Put on gloves to protect your hands.
- Take care not to scratch the body surface.

1. After loosening the mounting clip and screws, then remove the front mud guard (A).




2. Installation is the reverse of removal.

NOTE:
- Replace any damaged clips.

Rear Mud Guard Replacement

CAUTION:
- When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
- Put on gloves to protect your hands.
- Take care not to scratch the body surface.

1. After loosening the mounting clip and screws, then remove the rear mud guard (A).




2. Installation is the reverse of removal.

NOTE:
- Replace any damaged clips.

Rear Wheel Deflector Replacement

CAUTION:
- When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
- Put on gloves to protect your hands.
- Take care not to scratch the body surface.

1. After loosening the mounting clips, then remove the rear wheel deflector (A).




2. Installation is the reverse of removal.

NOTE:
- Replace any damaged clips.