Repair Procedures

Removal

Shift Lever Assembly Replacement
1. Remove the floor Interior console assembly.
2. Remove the select cable snap pin (A) and the clip (B) from the select cable assembly.








3. Remove the clip (A) from the shift cable.

CAUTION:
Set securely.




4. Remove the shift lever assembly (B) after removing shift lever assembly installation bolt (A).

Tightening torque:
9.8 - 14.7 N.m (1.0 - 1.5 kgf.m, 7.2 - 10.8 lb-ft)








5. Installation is the reverse of removal.

NOTE:
- Make sure vehicle does not roll before setting room side shift lever and T/M side manual control lever to "N" position.

Shift Cable Replacement
1. Remove the floor Interior console assembly.
2. Remove the select cable snap pin (A) and the clip (B) from the select cable assembly.








3. Remove the clip (A) from the shift cable.

CAUTION:
Set securely.




4. Remove the retainer (A) and nuts (B).

Tightening torque:
9.8 - 14.7 N.m (1.0 - 1.5 kgf.m, 7.2 - 10.8 lb-ft)




5. Remove the SRS Control Module.
6. Remove the pin and washer (A).
7. Remove the cable (B) from the cable bracket at manual transaxle assembly side.
8. Remove the shift cable and select cable at cabin room.






Inspection

1. Check the select cable for proper operation and for damage.
2. Check the shift cable for proper operation and for damage.
3. Check the boots for damage.
4. Check the boots for wear abrasion sticking, restricted movement or damage.
5. Check for the weak or damaged spring.

Installation

1. Installation is the reverse of removal.

NOTE:
- Make sure vehicle does not roll before setting room side shift lever and T/M side manual control lever to "N" position.
- Install the guide member (A) of the select cable (B).




- Adjust the slide clip (B) to fit it into the select lever pin (A) and install the snap pin (C).