Repair Procedures

Removal

NOTE:
Do not spill brake fluid on the vehicle; it may damage the paint if brake fluid does contact the paint, wash it off immediately with water.

1. Disconnect the push rod from the clutch pedal by removing the snap pin (A) and washer (B).




2. Remove the air cleaner assembly and air duct.
3. Disconnect the clutch tube (B) and reservoir hose (A) from the clutch master cylinder.




4. Remove the clutch master cylinder by turning it clockwise (A).






Installation

1. Installation is in reverse order of removal.
A. Perform bleeding air procedure in concentric slave cylinder after pouring the brake fluid.