Battery Cooling Duct: Service and Repair

Removal

WARNING:
This hybrid system uses a DC 270V voltage system. Be sure to follow safety instructions below. Failure to follow safety instructions may result in serious injury or electrocution .

1. Shut off the high voltage circuit .
2. Remove the trunk trim .
3. Remove the cooling ducts
(1) Remove the installation nuts (A), then remove the inlet cooling duct (B).








(2) Remove the installation nuts (A), then remove the outlet cooling duct (B).






Installation

WARNING:
This hybrid system uses a DC 270V voltage system. Be sure to follow safety instructions below. Failure to follow safety instructions may result in serious injury or electrocution .

1. Installation is reverse of removal.

Inlet cooling duct installation nut:
7.8 - 11.8N.m (0.8 - 1.2kgf.m, 5.8 - 8.7lb-ft)
Outlet cooling duct installation nut:
7.8 - 11.8N.m (0.8 - 1.2kgf.m, 5.8 - 8.7lb-ft)