Repair Procedures

Removal

1. Disconnect the battery negative cable, and wait for at least three minutes before beginning work.
2. To remove the seat belt anchor pretensioner (C), keep on pushing the lock pin (A) as arrow direction. And then remove the seat belt after pushing the lock pin (B).




3. Remove the door scuff trim.
4. Remove the center pillar trim.
5. Remove the upper anchor bolt.
6. Disconnect the seat belt pretensioner connector (A).




7. Loosen the seat belt pretensioner mounting bolts (B, C) and remove the seat belt pretensioner.

Installation

1. Remove the ignition key from the vehicle.
2. Disconnect the battery negative cable and wait for at least three minutes.
3. Install the seat belt pretensioner with bolts (B, C).

Tightening torque:
Bolt B: 39.2 - 53.9 N.m (4.0 - 5.5 kgf.m, 28.9 - 39.8 lb-ft)




4. Connect the seat belt pretensioner connector (A).
5. Install the upper anchor bolt.

Tightening torque:
39.2 - 53.9 N.m (4.0 - 5.5 kgf.m, 28.9 - 39.8 lb-ft)

6. Install the center pillar trim.
7. Install the door scuff trim.
8. Insert the seat belt to the anchor pretensioner.

NOTE:
Make sure the lock pin is connected in properly.

9. Reconnect the battery negative cable.
10. After installing the seat belt pretensioner, confirm proper system operation:
A. Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.