W/Harness Inspection

Engine Control
P0192 Fuel Rail Pressure Sensor Circuit Low Input - Inspection/Repair:_:W/Harness Inspection

Power Circuit Inspection

1. IG OFF.
2. Disconnect the Fuel Pressure Sensor (FPS) connector.
3. IG ON.
4. Measure the voltage between the power terminal of the FPS harness connector and chassis ground.

Specification :Approx. 5V








5. Is the measured voltage within specifications?






Signal Circuit Inspection

1. IG OFF.
2. Backprobe the signal terminal of the Fuel Pressure Sensor (FPS).
3. IG ON, engine OFF.
4. Measure the voltage between the signal terminal of the FPS connector and chassis ground.

Specification :Approx. 1V








5. Is the measured voltage within specifications?






Terminal and Connector Inspection

1. Many malfunctions in the electrical system are caused by poor harness(es) and terminals. Faults can also be caused by interference from other electrical systems, and mechanical or chemical damage.
2. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage.
3. Has a problem been found?