Verification of Vehicle Repair

Electronic Stability Control
C1207 Wheel Speed Sensor Rear-LH Range / Performance / Intermittent - Verification of Vehicle Repair

Verification of Vehicle Repair

After a repair, it is essential to verify that the fault has been corrected.
1. Connect GDS and select "Diagnostic Trouble Codes(DTCs)" mode.
2. Using a GDS, Clear DTC.
3. Operate the vehicle within DTC Detecting Condition in General Information. (Start and drive vehicle in gear and maintain vehicle speed at or above 12km/h. (7.5mph))
4. Are any DTCs present ?