Scantool Diagnostics

Airbag(Event #1)
B1353 Passenger Airbag Resistance too Low (1st stage) - Scantool Diagnostics

Monitor Scantool Data

1. Ignition "OFF", connect scantool.
2. Ignition "ON"& Engine "OFF", select "Current Data" mode.
3. Monitor the "Passenger airbag resistance" parameter on the Scantool.

Specification :1.1Ohms< Resistance of Passenger airbag(1st stage) < 6.7Ohms

Reference :In a case of an open in the Passenger airbag(1st stage) circuit : FAIL
In a case of a short to battery in the Passenger airbag(1st stage) circuit: FAIL
In a case of a short to ground in the Passenger airbag(1st stage) circuit : FAIL




Fig.1) Normal Data
4. Is parameter displayed within specifications?