Repair Procedures

Removal

1. Disconnect the negative (-) battery terminal.
2. Remove the crash pad center facia panel.

3. Disconnect the connector(A) from the crash pad center facia panel.




4. Remove the heater control unit(A).




5. Remove the mounting bolts then remove the audio unit(A).




6. Disconnect the audio connectors and cable(A).






Disassembly

1. Disassemble the front panel(A) then disconnect the connector(B) between the unit and front panel.




2. Remove the top cover(A) after loosening 4 screws.




3. Disassemble the deck (A) from the unit after removing the connector and screws.






Reassembly

1. Reassemble the deck to the audio unit.
2. Reassemble the top cover.
3. Reassemble the front panel and connect the connector.

External Amplifier
1. Remove the right side trunk trim and disconnecting the connector.

2. Remove the external amplifier(A) after loosening the nuts (2EA), bolt (1EA) and connector (B).






Installation

1. Connect the audio unit connectors and cable.
2. Install the audio unit.
3. Install the crash pad center facia panel.
4. Install the upper tray.
5. Check the audio system.

NOTE:
- Make sure the audio head unit connectors are plugged in properly, and the antenna cable is connected properly.

External Amplifier
1. Install the external amplifier and connect the external amplifier connector.
2. Install the right side trunk trim.