Monitor DTC Status

P0630 VIN not Programmed or Incompatible-ECM/PCM

Scantool Diagnostics - Monitor Scantool Data

Monitor Scantool Data

1. Ignition "OFF"
2. Connect Scantool and Ignition "ON"
3. Monitor the ECM status using the VIN READING function.
4. Is the ECM status Virgin?
YES
1) Perform VIN writing procedure according to the direction on the scantool screen and go to "Verification of Vehicle Repair" procedure.
NO
1) Fault is intermittent caused by poor contact in Sensor's and/or PCM's connector or was repaired and PCM memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and go to "Verification of Vehicle Repair" procedure

CAUTION:
There is a memory reset function on scantool that can erase optional parts automatically detected and memorized by PCM.
Before or after testing PCM on the vehicle, use this function to reuse the PCM on the others