Dome Lamp: Service and Repair

Inspection

Room Lamp
1. Check that the switch operates properly after disconnecting the room lamp connector (A).





[A type]





[B type]










Removal

Room Lamp
1. Disconnect the negative(-) battery terminal.
2. Carefully remove the lamp lens (A) from the room lamp with a flat-tip screwdriver.

NOTE:
Take care not to damage the part (B)

[A type]




[B type]




3. Replace the bulbs (A) and remove the screws if it is necessary.




4. Remove the room lamp assembly (A) after disconnecting the connector (B).





Vanity Lamp
1. Disconnect the negative (-) battery terminal.
2. Remove the vanity lamp (A) by pressing the clip (B) with a small screwdriver.




3. Remove the vanity lamp assembly after disconnecting the connector.

Installation

Room Lamp
1. Reconnect the connector.
2. Install the room lamp assembly.
3. Install the lens.

Vanity Lamp
1. Reconnect the vanity lamp connector.
2. Install the vanity lamp.