Power Door Lock Switch: Service and Repair

Inspection

Driver Door Lock Switch Inspection
1. Disconnect the negative (-) battery terminal.
2. Remove the front door trim panel.

3. Disconnect the connector from the power window switch module.




4. Check for continuity between the terminals in each switch position according to the table.






Removal

1. Disconnect the negative(-) battery terminal.
2. Remove the front door trim panel.

3. Remove the power window switch module (A) from the door trim after loosening the mounting screws (3EA).





NOTE:
- Be careful not to damage door trim panel and door module mounting hooks.

Installation

1. Install the power window switch module.
2. Install the door trim panel after reconnecting the relevant connectors

NOTE:
- Make sure that the power window switch module connectors are plugged properly.
- Check that the power window switch and door lock switch operate normally.