Output Speed Sensor (A4CF2)

Inspection

1. Check signal waveform of Input & output speed sensor using the GDS.

Specification:Refer to "Signal Wave Form" section.

Removal

1. Air cleaner assembly and air duct.

2. Remove the Hybrid Power Control Unit (HPCU) assembly.

3. Remove the under cover (A).

Tightening torque:
7.8 - 11.8 N.m (0.8 - 1.2 kgf.m, 5.8 - 8.7 lb-ft)




4. Replace new gasket and the plug after draining the automatic transaxle fluid by removing the drain plug.

5. Remove the ATF warmer.
" in this group)
6. Remove the AT tube (A) after removing eye bolt (B).

Tightening torque:
42 - 48 N.m (4.3 - 4.9 kgf.m, 31.1 - 31.4 lb-ft)




7. Remove the valve body cover (A) and breather hose clip (B).

Tightening torque:
(A) 13.8 - 15.7 N.m (1.4 - 1.6 kgf.m, 10.1 - 11.6 lb-ft)

NOTE:
Remove installation bolts in the engine room first and then remove others under the vehicle.




8. Remove the bolt (3ea) after disconnecting the solenoid valve connector (B) and the oil temperature sensor connector (A).

Tightening torque:
9.8 - 11.8 N.m (1.0 - 1.2 kgf.m, 7.2 - 8.7 lb-ft)




9. Remove the valve body assembly (A).

Tightening torque:
9.8 - 11.8 N.m (1.0 - 1.2 kgf.m, 7.2 - 8.7 lb-ft)




10. Disconnect the input & output speed sensor connector (A).
11. Remove the input & output speed sensor (B) after removing the bolts (2ea).

Tightening torque:
9.8 - 11.8 N.m (1.0 - 1.2 kgf.m, 7.2 - 8.7 lb-ft)





Installation

1. Installation is the reverse of removal.

NOTE:
After replacement or reinstallation procedure of the valve body assembly, must perform procedures below.
- Adding automatic transaxle fluid.
" in this group.)
- Bleed air from the hybrid motor cooling system using GDS.
" in HM group)