Repair Procedures

Removal

1. Remove the head lamp.

2. Disconnect the battery negative terminal in the right side luggage trim.
3. Disconnect the EWP (Electric water pump) connector (A).




4. Loosen the drain plug (A), and drain the inverter coolant. Remove the inverter reservoir cap to help drain the coolant faster.




5. Disconnect the EWP inlet hose (A) and outlet hose (B).




6. Remove the EWP (Electric water pump) (A).

Tightening torque:
8.8 - 10.8N.m (0.9 - 1.1kgf.m, 6.5 - 8.0lb-ft)




7. Installation is the reverse of removal.
8. Fill the radiator with coolant and check for leaks.

NOTE:
Bleed air from the hybrid motor cooling system using GDS.