Repair Procedures

Inspection

Front Door Lock Actuator
1. Remove the front door trim.

2. Remove the front door module.

3. Disconnect the connectors from the actuator.




4. Check actuator operation by connecting power and ground according to the table. To prevent damage to the actuator, apply battery voltage only momentarily.





Rear Door Lock Actuator
1. Remove the rear door trim.

2. Remove the rear door module.

3. Disconnect the connectors from the actuator.




4. Check actuator operation by connecting power and ground according to the table. To prevent damage to the actuator, apply battery voltage only momentarily.





Trunk lid Lock Actuator Inspection
1. Remove the trunk trim.

2. Disconnect the 3P connector from the actuator.




3. Check actuator operation by connecting power and ground according to the table. To prevent damage to the actuator, apply battery voltage only momentarily.





Front Door Lock Switch
1. Remove the front door trim.

2. Remove the front door module.
.
3. Disconnect the connectors from the actuator.




4. Check for continuity between the terminals in each switch position when inserting the key into the door according to the table.





Rear Door Lock Switch
1. Remove the rear door trim.

2. Remove the rear door module.

3. Disconnect the connectors from the actuator.




4. Check for continuity between the terminals in each switch position according to the table.





Trunk lid Switch
1. Remove the trunk trim.

2. Disconnect the 3P connector from the actuator.




3. Check for continuity between the terminals in each switch position according to the table.





Door Switch
Remove the door switch and check for continuity between the terminals.









Key In Switch
1. Remove the crash pad lower panel.

2. Disconnect the 6P connector from the key warning switch(A).




3. Check for continuity between the terminals in each position according to the table.