Parking Brake Shoe: Service and Repair

Parking Brake Shoe

Removal

1. Raise the vehicle, and make sure it is securely supported.
2. Remove the rear tire and wheel, then remove the brake caliper.
3. Remove the brake Disc (A).




4. Remove the rear hub unit bearing (A).




5. Remove the shoe hold down pin (A) and the spring (B) by pushing the retainer spring and turning the pin.




6. Remove the adjuster assembly (A) and the return spring (B).




7. Remove the parking brake cable (B) from the brake shoe (A).




8. Remove the strut (C) and the strut spring (D).




9. Remove the brake shoe.
10. Remove the parking brake cable retaining (B), from the parking brake cable (A).






Installation

1. Install the brake shoe(A) to the back plate(B).




2. Install the shoe hold down pin(C) and the spring(D) by pushing the retainer spring (D) and turning the pins.
3. After installing the strut (A) and upper return spring (B), install the adjuster assembly (C) and the lower return spring (D).




4. Install the parking brake cable (A), then install the retaining (B).




5. Apply a coating of the specified grease to each sliding parts of parking brake as shown.

Specified grease :
Multi purpose grease SAE J310, NLGI No.2




6. Install the rear brake disc, then adjust the rear brake shoe clearance.
(1) Remove the plug from the disc.
(2) Rotate the toothed wheel of adjuster by a screw driver until the disc is not moving, and then return it by 3 - 5 notches in the opposite direction.




7. Install the brake caliper.
8. Install the tire and wheel.
9. Adjust the parking brake lever.