Verification of Vehicle Repair

C1206 Wheel Speed Sensor Rear-LH Open/Short

Verification of Vehicle Repair

After a repair, it is essential to verify that the fault has been corrected.
1. Connect scantool and select "Diagnostic Trouble Codes (DTCs)" mode.
2. Using a scantool, Clear DTC.
3. Operate the vehicle within DTC Detecting Condition in General Information. (Start and drive vehicle in gear and maintain vehicle speed at or above 10 kmh. (6.2 mph))
4. Using a scantool, Check DTC present.
5. Are any DTCs present?