Repair Procedures

Replacement

1. Loosen the wheel nuts slightly.
Raise the vehicle, and make sure it is securely supported.
2. Remove the rear wheel and tire(A) from rear hub.

Tightening torque:
90 - 110 N.m (9 - 11 Kgf.m, 65 - 80 lb.ft)






CAUTION:
Be careful not to damage to the hub bolts (C) when removing the rear wheel and tire (A).

3. Loosen the mount bolt and then remove the brake mount bracket(A).




4. Remove the brake caliper mounting bolts (A), and then place the brake caliper assembly (B) with wire as shown in the illustration.

Tightening torque:
65 - 75 N.m (6.5 - 7.5 Kgf.m, 47 - 54 lb.ft)





5. Disconnect the wheel speed sensor connector(A) and then remove the hub bearing(B).

Tightening torque:
70 - 90 N.m (7 - 9 Kgf.m, 51 - 65 lb.ft)





6. Install in the reverse order of removal.