Ignition Switch: Service and Repair

Removal

1. Disconnect the negative (-) battery terminal.
2. Remove the steering column upper and lower shrouds (A).




3. Remove the ignition switch (A) after loosening the screw (B) with IG ON and disconnecting the 6P connector (C).




4. Remove the door warning switch and key illumination lamp (A) after loosening the screw and disconnecting the 6P connector (B).




5. If it is necessary to remove the key lock cylinder (A), remove the interlock cable.And then remove the key lock cylinder after pushing lock pin (B) with key ACC.






Installation

1. Install the key lock cylinder.
2. Install the interlock cable.

NOTE:
Install procedure for interlock cable
1. After setting key interlock cable and IGN lock assembly, fix the key interlock cable with pre-assembled set screw.
2. Install interlock cable in position.
3. Turn the key "Lock" state, and check the A/T change lever P position.

NOTE:
Check point of the key interlock system.
1. At "Lock" position, and brake pedal depressed, push button cannot be operated.
2. Key must not be turned to "Lock", except "P" position of A/T change lever.
3. At "P" position of A/T change lever, key must be turned to "Lock" smoothly.

3. Install the door warning switch and key illumination lamp.
4. Install the ignition switch.
5. Install the steering column shrouds.