Repair Procedures

Removal

1. Remove the lower crash pad. .
2. Disconnect the stop lamp switch connector (A).




3. Remove the mounting bracket bolt (B).

Tightening torque :
16.7 - 25.5N.m (1.7 - 2.6kgf.m, 12.3 - 18.8lb-ft)


4. Remove the snap pin (A) and clevis pin (B).




5. Remove the shift lock cable after removing the snap pin (C) and the clip (D).
6. Remove the brake pedal member assembly mounting nuts and then remove the brake pedal assembly.

Tightening torque :
16.7 - 25.5N.m (1.7 - 2.6kgf.m, 12.3 - 18.8lb-ft)







Installation

1. Installation is the reverse of removal.

CAUTION:
- Before installing the pin, apply the grease to the clevis pin.
- Use a new snap pin whenever installing.

2. Check the brake pedal operation.