Verification of Vehicle Repair

C1210 Wheel Speed Sensor Rear-RH Range / Performance / Intermittent

Verification of Vehicle Repair

After a repair, it is essential to verify that the fault has been corrected.
1. Connect scantool and select "Diagnostic Trouble Codes (DTCs)" mode.
2. Using a scantool, Clear DTC.
3. Operate the vehicle within DTC Detecting Condition in General Information. (Start and drive vehicle in gear and maintain vehicle speed at or above 40 kmh. (24 mph))
4. Using a scantool, Check DTC present.
5. Are any DTCs present?