Sunroof / Moonroof: Testing and Inspection

Adjustment

How To Initialize
1. Check that the glass has been installed.
A. Finished height adjustment.
2. Push and hold the up switch.
A. The slide moved 5mm forward after 15 seconds.




3. After moving the slide 5mm forward, turn OFF the switch and push the UP switch (Keeping pushing the switch of continuous operation)
A. When the motor initialization os successful, the sunroof should fully side open and close on time.
4. When the sunroof is closed completely, turn OFF the UP switch initialize the motor completely.

When To Initialize The Motor
1. Fist operation after the vehicle is manufactured.
2. If the initial setting is erased or a physical or el electrical malfunction.
3. After using the manual handle.

Operating The Sunroof Emergency Handle
1. Use the sunroof emergency handle to close or open the sunroof manually if the sunroof cannot be operated electronically due to motor or controller electrical malfunction.
A. Use this function to open or close the sunroof, before driving the vehicle, if the sunroof cannot be operated due to failure of the sunroof motor or controller.
2. Operating method
A. Remove the overhead console
B. Push the emergency handle up into the hexagonal drive (A) of the sunroof motor. You must push hard enough to disengage the motor clutch; otherwise the emergency handle will slip due to incomplete fit in the motor.
C. Carefully turn the emergency handle clockwise to close the sunroof.
D. After closing the sunroof, wiggle the handle back and forth as you remove the tool from the motor, to ensure the motor clutch reengages.
E. A 5mm hex socket may be used in place of the emergency handle, with a" Speeder" type handle.

CAUTION:
- Do not use power tools to operate the sunroof.
- Damage to the components may occur.