Scantool Diagnostics

Engine Control
P0011 A Camshaft Position-Timing Over-Advanced or System Performance (Bank 1) - Scantool Diagnostics:_:Monitor DTC Staus

Monitor DTC Status

1. Check DTC Status
(1) Connect scantool to Data Link Connector(DLC).
(2) IG "ON".
(3) Select "Diagnostic Trouble Codes(DTCs)" mode, and then Press F5(INFO) to check DTC's information from the DTCs menu
(4) Read "DTC Status" parameter.




(5) Is parameter displayed "Present fault"?
YES
1) Go to "System Inspection" procedure.
NO
1) Fault is intermittent caused by PCM memory was not cleared after repair. Erase DTC and drive the vehicle to satisfy the enable condition then, go to " System Inspection" procedure.