Service Procedure

Service Procedure:





1. Open the engine compartment and locate the emission label under the hood. Locate and write down the "Group" number found on the label for later form entry.





2. To start, use the Global Diagnostic System (GDS). Begin by clicking on "ID Register". Click on "Auto VIN" or manually enter vehicle information on the next screen.

*NOTICE
GDS must be updated to version N-K-01-07-0010 or later to properly collect data.





3. Choose "Engine" under "Select System" Click "OK" and follow screen instructions for connecting to vehicle.





4. To verify the VIN, select "Read VIN" under the "Vehicle S/W Management" menu. Click "OK" and write down the VIN for later form entry.





5.a. Select "System Identification".





5.b. Write down the "Calibration ID" or "ROM ID" number for later form entry. Next, go to the main screen by clicking on the "GDS" logo at the top left of the screen.





6. Then select "CARB OBD-II" under the "Diagnosis" tab.





7. Click on "IN-USE Performance Tracking" found in the CARB OBD-II list at the bottom left of the screen. Then click the "Expand" button at the top right corner of "IN-USE Performance Tracking" window.

*NOTICE
If all values indicate "Not Supported" or "0", check to make sure you have GDS software version N-K-01-07-0010 or later. If the software version is correct, and all values show "Not Supported" or "0", the vehicle will not qualify for this data collection, as it may have received a recent ECM Update or battery replacement/reset of the data values.





8. To capture the GDS data, click on the "Capture" button.











9. Select "Scantool Area - Full" and click "Send to file". The GDS will set up a designation folder and file name to save the captured data. Please change the file name to include the model/engine, the last 6 of the VIN and the date (mmddyyyy). Before saving, write down the file name and designation folder for further reference.





10. After saving the file, return to the GDS home page by clicking on "GDS" logo in the upper left hand corner.





11. Then click on the "Feedback" button.

*NOTICE
GDS must be connected to the internet to submit data.





12. Enter all the information requested in the form including your name and email address.

^ For System, enter "Engine"

^ For Subject, enter "Data Collection".

^ In the Description area,

^ Type "Group:" followed by the group number from the Vehicle Emission Control Information label in step 1.

^ Type "Calibration ID:" followed by the calibration ID obtained in step 5b.

^ Add current odometer mileage.

^ Add RO#.





13. To attach the data to the feedback form, click on the "Browse" button.








14. Refer to the file name and destination from step 9.

^ Navigate to: Local Disk (D:)/ gvciData/Record/

^ Click on the folder for the vehicle ie, "Sportage (KM)".

^ Click on the folder containing the vehicle VIN.

^ Click on the file name.

^ Once the file name appears in the "File Name" box, click on the "Open" button.

*NOTICE
Ensure that you attach the correct file by confirming it is the same as it is written down in step 9. Incorrect attachments render data submissions useless and are subject to a charge back of the warranty claim.





15. When the file name appears in the attachment field and all the information has been entered, click the "Submit" button.





16. Click on the "Close" button to finish.

*NOTICE
You may also print the data prior to submitting as record to attach to the RO.