Visual/Physical Inspection

P1692 Immobilizer Lamp error

Inspection/Repair - Visual/Physical Inspection

Visual / Physical Inspection

1. Check immobilizer lamp circuit
(1) Ignition "ON" & Engine "OFF"
(2) Check if immobilizer lamp operates properly.

CAUTION:
** Right after ignition "ON", Immobilizer lamp lights up for 30 sec.
If lamp blinks 5 times after ignition "ON", there's any fault in immobilizer system.

(3) Is immobilizer lamp operates properly?
YES
> Check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and then go to "Verification of Vehicle Repair" procedure.
NO
> Go to "Component Inspection" procedure.