W/Harness Inspection

P0130 O2 Sensor Circuit (Sensor1)

Inspection/Repair - W/Harness Inspection

Terminal and Connector Inspection

1. Many malfunctions in the electrical system are caused by poor harness and terminals.
Faults can also be caused by interference from other electrical systems, and mechanical or chemical damage.
2. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage.
3. Has a problem been found?
YES
1) Repair as necessary and go to "Verification of Vehicle Repair" procedure.
NO
1) Go to " Signal Circuit Inspection " procedure.

Signal Circuit Inspection

1. IG "OFF".
2. Disconnect HO2S (B1/S1) connector.
3. IG "ON" & ENG "OFF".
4. Measure voltage between terminal 2 of HO2S (B1/S1) and chassis ground.
A. Specification : Approx. 0.45 V




5. Is the measured voltage within specification?
YES
1) Go to "Ground Circuit Inspection" procedure.
NO
1) Repair or replace as necessary and then, go to "Verification of Vehicle Repair"procedure.

Ground Circuit inspection

1. IG "OFF".
2. Disconnect HO2S (B1/S1) connector.
3. Measure resistance between terminal 1 of HO2S (B1/S1) and chassis ground.
A. Specification : Approx. below 1 Ohms




4. Is the measured resistance within specification?
YES
1) Go to "Component Inspection" procedure.
NO
1) Repair or replace as necessary and then, go to "Verification of Vehicle Repair" procedure.