Key Warning Switch Inspection

Inspection

Key Warning Switch Inspection
1. Remove the driver's crash pad lower panel. (see Body group-crash pad)
2. Disconnect the 6P connector from the door warning switch.




3. Check for continuity between the terminals in each position according to the table.





Burglar Horn Inspection
1. Remove the burglar horn after removing 1 bolt and disconnect the 2P connector from the burglar horn.
2. Test the burglar horn by connecting battery power to the terminal 1 and ground the terminal 2.




3. The burglar horn should make a sound. If the burglar horn fails to make a sound replace it.