Sedan

Glass Replacement
1. Remove the front door trim.

NOTE:
- Use the door switch to align the mounting hole with the hole on the door glass.
- If it is impossible, align the hole by hand after removing the motor.
- Be careful not to drop glass and scratch the glass surface.

2. Carefully adjust the glass (B) until you can see the bolts, then loosen them, separate the glass from the glass run and carefully pull the glass out through the window slot.

Tightening torque :
8.8 - 11.8 N.m (0.9 - 1.2 kgf.m, 6.5 - 8.7 lb-ft)





3. Disconnect the connector (A)




4. Carefully adjust the glass (B) until you can see the bolts, then loosen them. Separate the glass from the glass run and carefully pull the glass out through the window slot.




5. Installation is the reverse of removal.

NOTE:
- Roll the glass up and down to see if it move freely without binding.
- Adjust glass position as needed.