Keyless Entry: Description and Operation

Description

Keyless Entry System
The burglar alarm system is integrated with the keyless entry system. The keyless entry system allows you to lock and unlock the vehicle with the remote transmitter. When you push the LOCK button, all doors lock. When you push the UNLOCK button again, all doors unlock.

You cannot lock or unlock the doors with the remote transmitter if the key is in the ignition switch.

The system will signal you when the doors lock and unlock by flashing the hazard lamp once when they lock and closed, and twice when they unlock.

Function

Keyless Entry Function
DOOR LOCK / UNLOCK and Trunk operations are performed with remocon
1. Keyless entry function is performed in a state that key in switch is eliminated from key cylinder
2. LOCK / UNLOCK and trunk signals are received from the transmitter and DOOR LOCK / UNLOCK and Trunk signals are output.
3. In case of tailgate, this operation is performed when pushing the button for 0.5s or more.

Transmitter(TX) Spec
1. Transmission Distance : 30m or more from outside of the car
2. Registration procedure of the transmitter
(1) In registration mode, it shall be possible to register up to Max 4EA.
(2) At re-registration, data are registered newly after deleting the previous TDATA





(3) For the registration procedures by using Hi-scan tool, refer to "TRANSMITTER CODE REGISTRATION".
3. Transmitter signal & Receiver Spec
(1) Transmission signal
A. Transmit relevant transmission DATA (Transmission frame) twice by pushing TSW.
B. Only LOCK signal is output when pushing TLOCK switch and UNLOCK switch at the same time.