Monitor DTC Status

C1260 Steering Angle Sensor Circuit-Signal

Scantool Diagnostics

Monitor Scantool Data

1. Connect scantool to Data Link Connector (DLC).
2. Ignition "ON" & Engine "ON".
3. Turn the steering wheel to the left or right.
4. Monitor the "STEERING ANGLE SNSR" parameters on the Scantool.

Specification :If the parameters are changed according to wheel position during steering the wheel, it is normal condition.




Fig 1) Normal data at turning the steering wheel into the left
5. Whenever steering wheel is turned, is the steering sensor's scantool data changed?